Sealing tester for medical devices
Product introduction:
Ym-b sealing tester for medical devices is designed according to the relevant provisions in the national standards for medical devices. It is used to test the sealing performance of infusion sets, blood transfusion sets, infusion needles, anesthesia bag filters, catheters, quick connectors, etc
Applicable standards: the medical device sealing tester is a special equipment designed according to the relevant provisions in the national standards for medical devices, which is specially used to test the sealing performance of medical devices.
Configuration requirements: main engine + 6m / M standard gas pipe 6m 2.3 pressure output range: higher than local atmospheric pressure, 20KPa ~ 200KPa,
Display mode: LED digital display; pressure output value can be set arbitrarily, and the calibration error is not more than ± 2.5% of the reading.
Test duration: 1s ~ 99.9 minutes, LED display, error is not more than ± 1s.
It is suitable for infusion set, blood transfusion set, infusion needle, anesthesia bag filter, pipeline, catheter, quick connector, etc.
usage method:
connect the tester to the network power supply, turn on the power switch, and the pressure gauge will display the local standard atmospheric pressure (LED shows 0000).
the pressure output of the tester is inserted into the air pipe connected with the tested object, and the other end of the gas pipe of the tested object is installed on the tested object, and the other end of the tested object is blocked. Then the immersed substance is immersed in water at 20 ℃ ~ 30 ℃ and the test button is pressed. The tester will automatically pressurize the air in the tested object to 20KPa (factory setting) and stop pressurization and start timing. When the time is 30 seconds, stop the test and the solenoid valve will close automatically. During the timing time, visually check for leakage.
Product Tags:
|
|
LED Digital Display 1s Sealing Tester For Medical Devices Images
|
